215794
113
Revision A
1011804
CXXX
EXXX
ACTIVATE REEL HT
DOWN/UP
D
C
B
A
Figure 5.122: Reel Height
7.
Press SELECT (D) until ACTIVATE REEL HT appears on the
upper line.
•
DOWN/UP will appear on the lower line.
DANGER
Ensure that all bystanders have cleared the area.
8.
Press and hold left arrow (B) to lower the reel. Press and
hold right arrow (C) to raise the reel. Ensure that the reel is
working properly.
9.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next ACTIVATE FUNCTION.
5.9.3
Testing Header Tilt Activate Function Using Cab Display Module
It may be necessary to use the cab display module (CDM) to change the angle of the attached header, rather than using the
header tilt controls on the ground speed lever (GSL).
NOTE:
•
The header must be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
•
The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1011772
C###
E###
WINDROWER SETUP?
NO/YES
A
B
Figure 5.123: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.