MacDon M155 2022, Руководство оператора

Страница: 318 / 526

215676
298
Revision A
Table 4.3 Draper Header Knife Speed Ranges for M Series Self-Propelled Windrowers (continued)
Header
Knife Speed
Type
Width
Minimum Speed Maximum Speed
rpm 28 spm 29 rpm 28 spm 29
Draper with
double knife
12.2 m
(40 ft.)
550 1100 700 1400
Draper
with single knife
6.1 and 7.6 m
(20 and 25 ft.)
600 1200 750 1500
Draper
with single knife
9.1 m
(30 ft.)
600 1200 700 1400
Draper
with single knife
10.6 m
(35 ft.)
550 1100 700 1400
Draper
with single knife
12.2 m
(40 ft.)
525 1050 600 1200
To adjust the knife speed, refer to Setting Header Knife Speed, page 91 .
4.6.8 Deck Shift Control
On windrowers with an attached draper header equipped with the deck shift option, the Operator can choose to deliver
crop to the left or right side of the header, in addition to being able to deliver the crop between the legs of the windrower.
Engaging Deck Shift
Engaging the deck shift option allows the Operator to choose to deliver crop to the left or right side of the header, in
addition to being able to deliver the crop between the legs of the windrower. The deck shift controls can be found on the
operator
’
s console.
DANGER
Ensure that all bystanders have cleared the area.
1000618
A
B
Figure 4.299: Header Drive Button
1. Start the engine.
2. Engage the header by pushing down on HEADER DRIVE
button (A) while pulling up on black ring (B) at the base of
the switch.
OPERATION
28. The values specified in this column refer to the speed of the knife drive box
’
s pulley.
29. Knife strokes per minute (rpm x 2)