215627
85
Revision A
5.2.2
Attaching D1X or D1XL Series Draper Header
The windrower may have an optional self-aligning hydraulic center-link, which allows control over the vertical position of
the center-link from the cab. If the windrower is so equipped, the procedure for attaching a D1X or D1XL header will be
slightly different.
NOTE:
Draper header supports must be installed onto the windrower lift linkage before starting this procedure. For instructions,
refer to
5.2.1 Attaching Draper Header Supports, page 84
.
$
%
%
Figure 5.27: Forming Shield bracket
–
R1 Series
NOTE:
If an R-Series Rotary header is also used, the forming shield
support brackets that are attached to the windrower lift legs
must be removed to avoid contacting the draper header.
1.
Remove hardware (B).
2.
Remove support bracket (A). Place the bracket and
hardware in the toolbox.
$
%
Figure 5.28: Forming Shield bracket
–
R2 Series