3. Turn knob to scroll to DRAPER setting (A) on
QuickMenu, and press knob to select it. The next
page opens.
Figure 4.215: Draper Header QuickMenu
4. Scroll
to
the
DEFAULT
DRAPER
ALARM
PRESSURE (A), and select it.
5. Change the alarm setpoint by scrolling. Scrolling past
the highest setting turns off the alarm. When the alarm
point is off, the digital value is replaced with three
dashed lines.
6. Adjust draper alarm pressure setpoint to desired value.
Figure 4.216: Draper Header Draper Page
Draper Slip Warning
If the left or right draper idler roller speed drops below 50%
of the target speed, a warning tone will sound and one
of the following messages (A) will appear on the Harvest
Performance Tracker (HPT) screen:
• Left draper slipping. Disengage header.
• Right draper slipping. Disengage header.
The Operator cannot cancel the message.
NOTE:
A slipping draper can severely damage the draper
belts. Slippage is typically caused by debris inside the
draper. A draper slip sensor failure will send a false slip
warning—disable the sensor and contact your MacDon
Dealer.
NOTE:
Draper slip warning is disabled when a double draper
drive kit is installed.
Figure 4.217: Draper Slip Warning
214053
207
Revision A
Содержание M1240
