Figure 4.165: HPT Display and GSL
Adjust the header angle as follows:
• To decrease (
fl
atten) header angle, operate the HEADER TILT UP switch (C) on the GSL to retract the cylinder.
• To increase (steepen) header angle, operate the HEADER TILT DOWN switch (D) on the GSL to extend the
cylinder.
NOTE:
The HEADER TILT switches (C, D) can be locked out to prevent unintentional header angle changes when
pressing the header height control switches (E, F). Refer to
3.17.6 Activating Control Locks, page 98
Checking Self-Locking Center-Link Hook
Periodically check the operation of the hook locking mechanism as follows and ensure that it is working properly:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator’s seat for any reason.
214053
187
Revision A
Содержание M1240
