215634
122
Revision B
1023033
A
B
Figure 4.25: HPT Header Disengaged Screen
10. Turn the IGNITION switch to crank position (A).
NOTE:
When the engine starts and the header is not engaged, the
HPT displays header disengaged page (B).
IMPORTANT:
•
Do
NOT
operate the starter for longer than 15 seconds
at a time.
•
If the engine does not start, wait at least 2 minutes
before trying again.
•
If you crank the engine for more than 30 seconds within
a 2-minute period, the engine will lock the starter circuit
to prevent overheating, and a flashing WTS symbol will
appear on the display. Wait for the WTS symbol to stop
flashing before attempting to crank the engine again.
•
If the engine still does not start, refer to the windrower
operator
’
s manual.
1019655
A
Figure 4.26: HPT No Header Screen
NOTE:
If you attempt to start the engine when the ambient
temperature is below 5°C (40°F), the engine will cycle
through a period during which it will sound as though it is
struggling to stay running. This is the engine
’
s warm-up
mode. The throttle will be unresponsive while the engine is
in warm-up mode. Warm-up mode lasts between
30 seconds and 3 minutes depending on the temperature.
The throttle will become active after the engine has
stabilized and is idling normally. Do
NOT
operate the engine
above 1500 rpm until the HPT engine temperature gauge is
above blue range (A).
4.1.11
Bleeding Brakes
–
Windrowers Sold In Germany Only
If the windrower is equipped with the secondary brakes package, you must bleed the brakes once before using them for
the first time.
NOTE:
This procedure requires two people. Have one person operate the Harvest Performance Tracker (HPT), and another person
at the drive wheels.