215634
88
Revision B
3.15
Installing Signal Light Placards, Markers, and Registration
Plate Mount
Follow these steps to install the signal light placards, markers, and registration plate mount.
1034448
A
B
C
D
C
Figure 3.98: M1170
NT5
Windrower
Two signal light placards (A) are located on the cab side, and
two signal light placards (B) on the walking beam side with two
end markers (C). The registration plate mount (D) is located just
below the cab at the front.
1.
Retrieve the four signal light placards, two markers, registration plate mount and bracket, and hardware from the cab.
Cab-side signal light placard
1034482
A
B
C
D
E
Figure 3.99: Cab-Side Signal Light Placard
–
Left Cab-
Forward, Top View
2.
Position left signal light placard (A) on left cab-forward
drive leg (B), and loosely secure with two M10 x 30 bolts
and lock nuts (C).
NOTE:
Bolts are installed from under the bracket.
3.
Adjust left signal light placard (A) so that there is a distance
of 58 mm (2 1/4 in.) (D) from the edge of the signal light
placard bracket to the edge of drive leg tower, and 37 mm
(1 1/2 in.) (E) distance at the rear of the plate as shown.
4.
Once the required distance is achieved, tighten
hardware (C) to secure signal light placard (A) to the drive
leg tower.
