MacDon M100, Инструкции по разгрузке и сборке

Страница: 43 / 49

PRE-DELIVERY CHECKS
Form # 169390 Model Year - 2010
41
VII. OPERATOR’S PRESENCE SYSTEM
CHECKS
a. With the windrower engine running, place the
GSL in Neutral and turn the steering wheel until
it locks.
CAUTION
Check to be sure all bystanders have cleared
the area.
b. With everyone clear of the machine, engage
header drive switch.
1. After header drives are running, stand up
out of the seat. In approximately 5 seconds
the header should shut off. If not, the
operator presence system requires
adjustment, refer to the M100 Operator’s
Manual for adjustment procedures.
NOTE
To restart the header, move the
header engage switch to “OFF”
position and back to the “ON” position
again.
c. With the windrower moving at less than 3 mph;
1. Stand up out of the seat.
2. The CDM will flash “NO OPERATOR” on the
upper line, and “ENGINE SHUTDOWN
5…4…3…2…1…0” on the lower line
accompanied by a steady tone. At “0”, the
engine shuts down.
3. If the engine does not shut down, the
operator presence system requires
adjustment, refer to the M100 Operator’s
Manual for adjustment procedures.
d. With the windrower moving at more than 3 mph;
1. Stand up out of the seat.
2. The CDM beeps once and displays “NO
OPERATOR” on the lower line.
3. If not, the operator presence system
requires adjustment, refer to the M100
Operator’s Manual for adjustment
procedures.
VIII. EXTERIOR LIGHTS
a. Switch on field lights and check that all lights as
shown are functioning.
b. Turn off lights.
(continued next page)
REAR
FIELD LIGHTS
SWATH LIGHTS
FRONT
FIELD LIGHTS