MacDon HC10, Оригинальная инструкция

Страница: 93 / 242

215126
71
Revision A
Adjusting Forming Shield Height
The height of the forming shield affects the shape and consistency of the windrow. A heavy crop will require the forming
shield to be set near the highest position and a lighter crop needs the forming shield to be lower. Adjust the forming shield
height as follows:
WARNING
To avoid injury or death from unexpected start-up of machine, always stop the engine and remove the key from the
ignition before leaving the operator
’
s seat for any reason.
1. Shut down the engine, and remove the key from
the ignition.
1005067
A
B
Figure 4.36: Rubber Strap
2. Remove hairpins (A) securing straps (B) to pins on
windrower frame.
3. Support aft end of forming shield. Adjust the shield height
using the holes in the straps.
4. Secure straps with hairpins.
Adjusting Side Deflectors
The position of the side deflectors controls the width and placement of the windrow. To adjust the position, follow
these steps:
WARNING
To avoid injury or death from unexpected start-up of machine, always stop the engine and remove the key from the
ignition before leaving the operator
’
s seat for any reason.
1. Shut down the engine, and remove the key from
the ignition.
1005068
A
B
C
Figure 4.37: Side Deflector
–
Right
2. Set side deflectors (A) to the desired width by loosening
handle (B) and moving deflector (A). Tighten the handle.
Repeat at opposite side. Set both deflectors to
approximately the same position.
IMPORTANT:
To ensure windrow placement is centered with respect to
windrower wheels, adjust both side deflectors to the same
position. To achieve this setting, adjuster handles must be
in the same location on both sides.
3. If side deflector attachment is too tight or too loose,
tighten or loosen nut (C) as required.
OPERATION