MacDon HC10, Руководство по эксплуатации и запасным частям

Страница: 153 / 156

Predelivery Checklist
Perform these checks and adjustments prior to delivery to your Customer. Refer to Unloading and Assembly
Instructions for adjustment details. The completed checklist should be retained either by the Operator or the Dealer.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages, which bring your attention to
hazards and unsafe practices.
Conditioner Serial Number: _____________________________________________
Table 1 HC10 Hay Conditioner Predelivery Checklist

Item Reference
Check for shipping damage or missing parts. Be sure all shipping
dunnage is removed.
—
Check roll drive belt tension.
3.13.1 Checking Roll Drive Belt
Tension, page 48
Check conditioner roll gap, timing, and alignment.
3.13.2 Checking Roll Gap, page 49
and
3.13.3 Checking Roll Timing, page 49
Check rear and side forming shields evenly set to desired position.
3.10 Installing the Forming Shield,
page 42
Grease all bearings.
3.12 Lubricating the Conditioner, page
45
Check roll intermesh hardware is securely tightened. 4.9.2 Adjusting Roll Gap, page 70
Check hydraulic hose routing.
4.3 Attaching Hay Conditioner to
Header, page 55
Run-up procedure
3.13.4 Running Up the Conditioner,
page 50
Check reverse operating mode. Refer to windrower manual.
Check hydraulic hose routing for clearance when raising or
lowering header.
—
Post run-up checks. Stop engine.
—
Check for hydraulic leaks. —
Check belt drive for alignment and heated bearings. 5.7 Drive Belt, page 84
Check manuals in windrower cab. 3.13.5 Storing Manuals, page 51
Date checked:
Checked by :
214033
143
Revision A