![background image](http://html.mh-extra.com/html/macdon/flexdraper-fd2-series/flexdraper-fd2-series_installation-instructions-manual_685696032.webp)
215505
26
Revision A
$
%
Figure 5.3: Tine Tube
4.
Slide the new finger and tine tube arm (A) onto the end of
the tube.
5.
Attach the fingers to the tine tube with bolts and nuts (B).
For finger location and proper hardware installation refer to
3 Steel Finger Placement, page 9
6.
Torque steel finger hardware to 35 Nm (26 lbf·ft).
NOTE:
Do NOT overtighten hardware, may result in flattening of
tube.
$
%
Figure 5.4: Bushing
7.
Install bushing clamp (A) onto the tine tube adjacent to the
flangeless end of bushing (B).
8.
Position clamp (A) on bushing (B) so the edges of the clamp
and bushing are flush when the clamp is fit into the groove
on the bushing and the lock tabs are engaged.
NOTE:
Clamp is not symmetrical, inner flange needs to be to the
outside.
$
%
Figure 5.5: Installing Clamp
9.
Tighten clamp (A) using modified channel lock pliers (B)
until finger pressure will not move the clamp.
NOTE:
Make sure notches are engaged between clamp and
bushing.
IMPORTANT:
Do NOT overtighten the clamp, it may result in breakage.