![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032099.webp)
214685
87
Revision A
5.4
CLAAS Combines
The FD1 Series FlexDraper® Header is compatible with CLAAS 500, 600, and 700 Series combines.
5.4.1
Attaching Header to CLAAS Combine
WARNING
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
Figure 5.60: Pins Retracted
1.
Move handle (A) on the Float Module into the raised
position, and ensure pins (B) at the bottom corners of
the float module are retracted.
Figure 5.61: Header on Combine
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
2.
Start the engine and slowly drive the combine up to the
header until feeder house saddle (A) is directly under
float module top cross member (B).
3.
Raise the feeder house slightly to lift the header,
ensuring the feeder saddle is properly engaged in the
float module frame.
4.
Stop the engine and remove the key from the ignition.
Содержание FlexDraper FD1 Series
