![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032036.webp)
214685
24
Revision A
3.2
Attaching Cam Arms
To attach the reel cam arms, follow these steps:
Figure 3.16: Disconnected Cam Links and
Shipping Wire
1.
Rotate the reel manually until the tine bars with
disconnected cam links are accessible.
2.
Remove shipping wire (A) (if not already removed).
Figure 3.17: Hardware Bag Right Reel
3.
Remove bag of hardware (A) from tine bar. It contains
hardware for cam links and endshields.
Figure 3.18: Bar Crank Attachment Holes and
Link Alignment
4.
Rotate tine bar crank (A) and position link (B) so
attachment holes in bar crank are aligned with hole
in link.
5.
Install bolt (C) in link and position shim (D) on bolt so
that shim is between link and tine bar crank.
NOTE:
Bolts are precoated with Loctite
®
, so no further locking
method is required.
6.
Realign link (B) and tine bar crank (A) and thread in
bolt (C).
7.
Repeat for remaining tine bars and torque bolts to
165 Nm (120 lbf·ft).
Содержание FlexDraper FD1 Series
