![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032111.webp)
214685
99
Revision A
Opening Endshields
Figure 5.87: Left Endshield
1.
Push release lever (A) located on the backside of the
endshield to unlock the shield.
2.
Pull endshield open using handle depression (B).
Figure 5.88: Left Endshield
3.
Pull endshield at handle depression (A). Endshield is
retained by a hinge tab (B) and will open in
direction (C).
Figure 5.89: Left Endshield
4.
If additional clearance is required, pull the endshield
free of hinge tab (A) and swing shield towards the rear
of the header.
5.
Engage safety latch (B) on hinge arm to secure the
shield in fully open position.
Installing Crop Divider without Latch Option
NOTE:
If the crop divider latch option was ordered with the header, proceed to
Installing Crop Divider with Latch Option,
. Otherwise, complete the following procedure:
Содержание FlexDraper FD1 Series
