MacDon FD75, Руководство пользователя

Страница: 21 / 28

Straight Cut Canola Optimization
Draper Clinic Handout
20
Feed Auger Optimization for Canola- Spring Tension
• Decrease spring tension to allow feed auger to “Float Up” for higher throughput
• Decrease LH and RH feed auger spring tension by loosening tensioning bolt
until 15mm (.60 inches) of thread remains on the end of the tensioning bolt
from the end of the bolt to the nut.
• Ensure top jam nut is locked to new setting
Canola Feed Auger Optimization- Fingers
• A dd finders to F eed A uger.
• 2012 and Prior- 15 fingers installed at factory
• 2013 and Newer- 17 fingers installed at factory
• Provisions for 25 fingers in feed auger
• 56” to 60” Feeder openings- Full Compliment (25) *
• 45” to 55” Feeder Openings- (23) *
• 30” to 44” Feeder Openings- (17-19) *
Finger (box of 5) Part Number- 220938
Hair Pin Part Number to Retain Finger- 123180
* Ensure fingers are inboard min 2” (50mm) on Feeder
Opening of Combine. Number of fingers may vary to achieve
this, above is a guideline.
Fingers added in these blanked off
slots to both LH, RH
RH Spring Shown
Upper Cross Auger for Straight Cut Canola
• An Upper Cross Auger is necessary to aid in conveying and assist moving
crop laterally in conjunction with the side drapers to the feed auger
B4847 - 30’ (9.1m)
B4848 - 35’ (10.6m)
B4849 - 40’ (12.2m) and 45’ (13.7m)
If you already have an Upper Cross Auger, ensure that the center paddles are
outfitted with carriage or couch head bolts to prevent crop wrapping.
Find your operators manual at: www.macdon.com/support/operators-manuals