MacDon DWA, Инструкция по установке, эксплуатации и каталог запасных частей

Страница: 73 / 140

215626
63
Revision A
To adjust the deck angle relative to the right drive wheel, follow these steps:
$
%
&
'
Figure 3.9: Adjusting Turnbuckle
2. Loosen locking tab (B) on the adjustable turnbuckle.
3. Rotate center tube (A) to the desired length.
NOTE:
The turnbuckle length should be approximately:
•
R Series Rotary Disc Header: 530 mm (21 in.) long.
•
A Series Auger Header or D Series Draper Header:
630 mm (25 in.) long.
4. Tighten locking tab (B) against turnbuckle center tube (A).
5. Attach the turnbuckle to connection point (C) for an
R Series header, and at connection point (D) for an A Series
or D Series header.
3.5.2 Adjusting Deck Angle Relative to Ground
Generally, the deck should be parallel or at a slight angle to the ground.
$ %
Figure 3.10: DWA Deck
The deck angle should be horizontal or at a slight incline relative
to the ground. Distance (A) should be equal to or slightly greater
than distance (B).
•
If the DWA is being used with an R Series Rotary Disc
Header in lighter crop, distance (A) should be equal to (B).
•
If the crop needs to be thrown farther, increase distance (A).
To adjust the deck angle:
$
%
&
'
Figure 3.11: Deck Pivot
1. Loosen four 3/4 in. bolts (A).
NOTE:
The fourth bolt is hidden behind bracket (B) and is not
visible in this illustration.
2. Loosen locking nut (D).
3. To increase the distance between the ground and the deck,
tighten nut (C).
4. To decrease the distance between the ground and the deck,
loosen nut (C).
5. After your adjustments are complete, tighten nut (D).
6. Torque four 3/4 in. bolts (A) to 332 Nm (245 lbf·ft).
OPERATION