![background image](http://html.mh-extra.com/html/macdon/d50/d50_operators-manual_685672159.webp)
169441
147
Revision D
1009493
B
C
A
Figure 4.56: Pointed Guards
5.
Position new guard (A), hold-down (C) (if applicable), and
plastic wearplate (if applicable) onto the cutterbar. Secure
with two nuts (B) and bolts, but do
NOT
tighten.
6.
Check and adjust the clearance between the hold-downs
and the knife. For instructions, refer to
Adjusting Knife Hold-Downs, page 151
NOTE:
The guard at the center of a double-knife header (where
the two knives overlap) requires a different replacement
procedure. For instructions, refer to Steps
through
.
Replacing center guards
7.
Shut down the engine, and remove the key from the ignition.
1001459
B
A
C
D
Figure 4.57: Center Guards
8.
Remove two nuts (B) and bolts attaching guard (A) and
hold-down (C) to the cutterbar.
9.
Remove guard (A), plastic wearplate (if installed), hold-
down (C), and adjuster bar (D).
Содержание D50
Страница 101: ...169441 89 Revision D 10 Tighten bolts B OPERATION ...
Страница 124: ......
Страница 295: ...topsoil moisture 83 types 80 weather and topography 83 WOT definition 19 INDEX ...
Страница 296: ......