215184
480
Revision A
1016110
A
Figure 9.387: New Holland Combine Display
3.
Select HEADER (A) from the list of calibration options.
1016111
Figure 9.388: New Holland Combine Display
4.
Follow the calibration steps in the order in which they
appear on the screen. As you proceed through the
calibration process, the display will automatically update to
show the next step.
NOTE:
Pressing the ESC key during any of the steps or letting the
system sit idle for more than 3 minutes will cause the
calibration procedure to stop.
NOTE:
Refer to your combine operator
’
s manual for an
explanation of any error codes.
1016112
Figure 9.389: New Holland Combine Display
5.
When all steps have been completed, CALIBRATION
COMPLETED message is displayed on the screen.
NOTE:
If float was set heavier to complete AHHC calibration
procedure, adjust to recommended operating float after
the calibration is complete.
Checking Reel Height Sensor Voltages
–
New Holland CR Series
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.