215184
459
Revision A
Calibrating Header
–
John Deere S7 Series
WARNING
Never start or move the machine until you are sure all bystanders have cleared the area.
Feeder house calibration must be done before header calibration. If feeder house has not yet been calibrated, refer to
John Deere S7 Series, page 456
.
For best performance of auto header height control (AHHC), perform these procedures with the center-link set to
D
. When
setup and calibration are complete, adjust center-link back to desired header angle. For instructions, refer to Header Angle
in the header operator
’
s manual.
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
1.
Ensure center-link is set to
D
.
2.
Rest header on down stops and unlock float.
1022778
A
Figure 9.345: John Deere S7 Display
–
Harvesting Page
3.
On the HARVESTING page, select MENU icon (A) in the
bottom right corner of screen. The MENU opens.
1022786
A
B
Figure 9.346: John Deere S7 Display
–
Machine
Settings
4.
Select MACHINE SETTINGS tab (A).
5.
Select CALIBRATIONS & PROCEDURES icon (B). The
CALIBRATIONS & PROCEDURES page displays.