215184
172
Revision A
5.8
Installing Driveline
CAUTION
To prevent injury to the installer and damage to the driveline, hold the driveline so that it doesn
’
t fall to the floor or
ground.
NOTE:
Case New Holland drivelines are stored in a lower position on the float module. If installing a Case New Holland driveline,
proceed to Step
1021125
A
B
Figure 5.36: Driveline Support
1.
Position driveline storage support (A) onto the left frame of
the float module. Secure in place with two M10 carriage
bolts and hex flange nuts (B).
1024058
A
B
C
Figure 5.37: Driveline Support
–
Case New Holland
2.
Case New Holland only:
Position driveline storage
support (A) onto left side of bracket (B) as shown. Secure in
place with two M12 hex head bolts (C) and hex flange nuts.
NOTE:
The support for 21-tooth spline drivelines is shown in the
illustration at right. The support for 6-tooth spline
drivelines is similar.