MAC215986
217
Revision A
1003775
Figure 3.318: New Holland Calibration Dialog Box
2.
Move the header to the desired maximum stubble height
using the header up or down control switch on the
multifunction handle.
NOTE:
Set the header to a height which will never be attained
while harvesting. This will ensure that the harvest area
counter never stops recording harvesting data while the
auto header height control (AHHC) system is active.
3.
Press ENTER to continue. As you proceed through the
calibration process, the display will automatically update to
show the next step.
4.
Press ENTER or ESC to close the calibration screen. The
calibration is now complete.
Adjusting Header Raise Rate
–
New Holland CR/CX Series
If necessary, the header raise rate (the first speed on the HEADER HEIGHT rocker switch of the multifunctional handle) can
be adjusted.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
1003628
Figure 3.319: New Holland Combine Display
1.
Select HEADER RAISE RATE on the combine display.
2.
Use the + or
–
buttons to change the setting.
3.
Press ENTER to save the new setting.
NOTE:
The raise rate can be changed from 32
–
236 in increments
of 34. The factory setting is 100.
Setting Header Lower Rate
–
New Holland CR/CX Series
If necessary, the header lower rate (the automatic header height control button or second speed on the header height
rocker switch of the multifunction handle) can be adjusted.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for the most up-to-date information.
