![background image](http://html.mh-extra.com/html/macdon/a30-d/a30-d_assembly-instructions-manual_685647018.webp)
UNLOADING AND ASSEMBLY
Form 169078
Revision C
18
g. Set forming shield side deflectors to desired
width by repositioning adjuster bars (F). Use
same hole location on both sides.
•
Position deflectors at the narrowest
setting for a narrow windrow (silage for
example).
•
Position deflectors at the widest position
for a wide window.
NOTE
Refer to the Operator’s Manual or Quick
Card for additional information on
adjusting the forming shield.
h. Adjust fluffer shield (G) to middle position.
Loosen handles (H) if required.
STEP 13. ATTACH HEADER TO
WINDROWER
a. Remove pins (A) from left and right header
boots.
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight box attached to
windrower, ensure that float engagement
pin is installed in storage location (C), and
not installed at hole location (D).
CAUTION
Check to be sure all bystanders have cleared
the area.
b. Start the engine, and activate HEADER DOWN
button on the GSL to fully retract header lift
cylinders.
(continued next page)
HEADER UP
HEADER TILT UP
HEADER DOWN
HEADER
TILT DOWN
B
A
BOTH SIDES
G
H
F
D
C
Содержание A30-D
Страница 53: ...NOTES Form 169078 Revision C 53 ...
Страница 55: ......