Macab IP-1000 TX, Руководство по эксплуатации

Страница: 7 / 8

Operating Instructions
7
Setup the TX or the RX (need FW 1.07 or newer)
A HTTP server is embedded in each TX and RX. You can setup the HDMI extender via web browser.
The default IP address of the TX is 192.168.168.55 and the RX is 192.168.168.56. No matter what you
assign the device IP address the default IP address will reload when a Reset is performed.
Step 1 : Assign the PC or laptop IP address through Control Panel, Network Connections, Local Area
Connections Status, Properties, Internet Protocol (TCP/IP), Use the following IP address. Type the IP
address field with 192.168.168.11(0-255) and Subnet mask with 255.255.255.0. After that press OK
to save the configuration.
Step 2: turn on the device, the red light becomes lighting, waiting about 10 seconds, the green light
starts working, at this time to press the reset button about 5-10 seconds to turn off the green light.
Step 3 : Use an Ethernet Cable to connect the PC or laptop and the device. The power LED is still red
and the status LED becomes green blink.
Step 4 : Ping the connected device through the sequence, Start, Run, cmd, ping 192.168.168.55 (TX)
or ping 192.168.168.56 (RX). You will receive the reply if the connection is established. Use IE browser
to get access the web server. You can set IP address, Subnet mask, Gateway, and MAC address in this
page.
Destination: one “TX to many RX” or many “TX connect to many RX”, IP and MAC address must be
different.
Step 5 : After click Apply button, the device shows Status LED green turn off. Turn off the device.
Download: www.macab.com >
Premium Brand (Catline)