Instruction for Use
8. Install four 8-32 X 1/2” screws (Table 9, Item 3)) to attach the air box to the bottom of the drawer.
9.
Finishing the Cabinet Re-assembly for Free Standing Units
A. Re-install the outer and inner top panels, securing with two 8 X 1-5/8” self-tapping screws (Table 1, Item
4) to the Inside Top Panel (Table 1, Item 1) and four 8 x 1-5/8” self-tapping screws to the Outside Top
Panel (Fig. 1).
10.
Finishing the Cabinet Re-assembly for Units Situated in Recessed Walls
A. Plug in the unplugged connectors, plugs and probe wire. (Fig. 4, Fig. 5 or Fig. 6). If a TS series unit, also
plug in the Ethernet connection.
B. Slide the Drawer Assembly back into the Warming Cabinet.
iii.
Important:
Ensure proper door switch operation -
For both steel and glass door units, the top Drawer
Assembly should be re-installed to sit flush with the front surface of the door frame edge. For steel
door units, the lower Drawer Assembly front surface should sit flush with the front surface of the door
frame edge. For glass door units, the lower Drawer Assembly front surface should be re-ijnstalled to
sit recessed up to 1/8” below the front surface of the door frame edge.
D. Align the two holes (located bottom-front) on the drawer with the two holes in the rail guides in the
Warming Cabinet. Secure the Drawer Assembly to the cabinet guide rails by attaching two 8-32 X 1/2”
self-tapping screws (Table 1, Item 2) into the holes of the guide rails of the cabinet (Fig. 1).
6. Place the Fan Guard (Table 9, Item 2) against the bottom of the Drawer Assembly and align the two tabs
with holes in the bottom of the drawer. Install two 8-32 X 1/2” screws (Table 9, Item 3) and attach the guard
to the drawer.
7. Place the Air Box (Table 9, Item 4) over the Fan Guard on the bottom of the Drawer Assembly (Table 9, Item
1). Align the four holes in the air box with four holes in the bottom of the drawer. Make sure that the probe
wire that is attached to the Air Box is to the rear of the Warming Unit.
Table 9 (Fig. 16)
Item #
DESCRIPTION
QTY
1
Drawer Assembly
1
2
Fan Guard
1
3
Screw, 8-32 X 1/2, Pan Head
6
4
Air Box
1
Fig. 16: Exploded view - Airbox and Fan Guard
6
Instruction for Use -
Replacing Fan Motor for D and TS series
Warming Cabinets
Printed in USA
Publication No. IFU-130 Rev A
January 2018
Information regarding this product is
subject to change without prior
notice.
