EN
EN
10
11
Getting started...
Getting started...
MPS750S-2
MPS750S-2
Pinching the saw chain along the top of the guide
bar may push the guide bar rapidly back towards the
operator.
Either of these reactions may cause you to lose control
of the saw which could result in serious personal injury.
Do not rely exclusively upon the safety devices built into
your saw. As a product user, you should take several
steps to keep your cutting jobs free from accident or
injury.
Kickback is the result of tool misuse and/or incorrect
operating procedures or conditions and can be avoided
by taking proper precautions as given below:
1. Maintain a firm grip, with thumbs and fingers
encircling the product handles, with both hands
on the saw and position your body and arm to
allow you to resist kickback forces.
Kickback
forces can be controlled by the operator, if proper
precautions are taken. Do not let go of the product.
2. Do not overreach.
This helps prevent unintended
tip contact and enables better control of the product
in unexpected situations.
3. Only use replacement bars and chains specified
by the manufacturer.
Incorrect replacement bars
and chains may cause chain breakage and/or
kickback.
4. Follow the manufacturer’s sharpening and
maintenance instructions for the saw chain.
Decreasing the depth gauge height can lead to
increased kickback.
than intended could result in a hazardous situation.
16. Pay attention to national and local regulations.
National and local regulations may restrict the use
of this product.
17. Only use replacement guide bars and saw chains
specified by the manufacturer or equivalent
replacements. Using non-approved cutting
attachments can result in personal injuries and
damage to property.
18. Before using the product and after any impact or
dropping, check for signs of wear or damage and
repair as necessary.
19. Never remove or modify any guard or safety
component. Ensure that guards and other safety
components necessary for machine operation are
in position, in good working condition and properly
maintained to avoid injuries.
20. Training of all operation is necessary for first-time
and inexperienced operator.
21. Remove branches in section.
22. Use the harness provided.
Causes and operator prevention of kickback
Kickback may occur when the nose or tip of the guide
bar touches an object, or when the wood closes in and
pinches the saw chain in the cut.
Tip contact in some cases may cause a sudden
reverse reaction, kicking the guide bar up and back
towards the operator.
Technical and legal
information
Technical and legal
information
