work now.
1)
the working condition should be dry, air humidity should less than 90%
2)
the temperature should around -10
0
～
40
0
.
3)
avoid work in the sun and rain, never let water go inside of the machine.
4)
Avoid work in the dusty or cautic air.
5)
Avoid working in strong air
Safety notice:
with over voltage,over current and over heat protection,the welding machine will stop working when
the voltage ,output current and heat is exceed the standard setting . But the machine may broken
by over loaded works (when the voltage is too high), so we need take care of following conditions :
1)
Make sure the workplace is well ventilated. As the machine
’
s dimension is not so big, so the it
require better ventilation when strong current passed through . workers should make sure the
ventilate part is not blocked ,and the machine should keep 0.3 m away from other goods, in that
way, the machine can work better and can keep long working life.
2)
Forbidden over load working workers shold check max load current (according to rated duty
cycle),keep the welding current less than max load current. Over load working will reduce life
of the machine,and may even burn it.
3)
Avoid over voltage normally, voltage compensate circuit can ensure the welding current keeps in
standard scope.If the voltage is exceed, the machine may burned, so the user should notice it
and avoid it.
4)
If the duty cycle is exceed , the welding machine may self protected and stop work .it means the
duty cycle is exceed, over heat protection works, so the machine stop working, and the red light
on the panel is on. In such case, you don't need cut off the power, you should let the fan work
and the machine will be cooled after some minutes. When the red light is off, the machine can continue
work again
The normal problem in welding process
The below problem may caused by accessory , the workpiece, the circumstance, the power
supply, etc, so you should provide good working condition ,avoid following problem.
A. strick arc difficulty and unstable arc .
（
1
）
make sure the earth clamp and the workpiece is well connected.
（
2
）
check every connection.
B. output current cant reach rated current.
The input voltage is not same as rated voltage , so the current is not same as the setting.
C.
The current is not stable in welding.
The max output current less than rated, it may caused by below:
(1)
The input voltage is changed
(2)
The influence comes from electricity net and other equipments.
D.
the welding slot is with gas bubble.
1)
check the gas supply ,make sure no leak of gas.
2)
Check the workpiece, make sure no oil, dusty on it.
Maintain:
