Mableaudio 5E3, Инструкция по сборке, Страница: 9 / 39

Install two rubber grommets for the output transformer wires to pass through
Install the output transformer with the green and black leads towards the output jacks. Run the wires through the
grommets, and pull them towards the rear of the chassis to keep them out of the way of the circuit board.
Note: If you wish, you may hold off on installing the output transformer until later. This will make it easier to
complete the next few steps, but it will be more difficult to bolt the transformer down if you do it this way.
Make sure that all the wiring on the back side of the circuit board is correct before proceeding to the next
step! Any errors made will be extremely difficult to repair after the board is wired in.
Before installing the circuit board, make sure that all of the wires are bent upwards, so none of them become
buried under the board. Align the two screw holes with the standoffs and carefully screw the board down. Don’t
force the screws if the board doesn’t want to go all the way into place.