mabe LMD1841B, Руководство пользователя, Страница: 16 / 24

16
rinse
rinsing with clear water
1. Place the clothes in the wash tub. Select the desired water flow
according to the load.
2. Adjust the water level: Set the water level with the water level
adjustment lever according to the size of the load. Then fill the
tub continuously until reaching the desired water level.
rinsing with used water
1. Place the clothes in the wash tub. Select the water flow according
to the size of the load.
2. Fill with water until reaching the preset water level.
3. Rinse. Set the wash timer for 2 to 3 minutes of rinsing. When the
load is small, use the GENTLE setting, if you use the NORMAL set-
ting instead, water could splash.
When water comes out
from this window, reduce
the water supply rate.
3. Rinse. Set the WASH timer in 5-7 minutes of rinsing. Repeat the
spin at the middle of the cycle and rinse with used water 2 to 3
times.
spin
1. Place clothes in the spin tub and distribute them evenly.
2. Push the top cover against the load. Close internal and external
covers of the spin tub.
3. Select a suitable spin time according to the size of the load and
start spinning.
• During spin cycle, abnormal sounds are usually caused by un-
even distribution of the load or the load being piled up on one
portion of the tub. You must stop the machine and evenly redis-
tribute the load.
• If you open the external cover of the spin tub, the spin cycle
stops. Close the lid to restart the spin cycle.
• To spin and drain, or to rinse and fill the tub with water simulta-
neously, you must first spin only for a minute. Then, drain or
rinse while filling the tub with water. Otherwise, the spin will
stop because there will be too much water stored in the spin
tub.