mabe Kraken, Руководство по обслуживанию

Страница: 53 / 88

Ingeniería de Servicio
- 53 -
Consumer Error Mode Entry
Entry into Consumer Error Mode

From an idle state only (all LEDs off), press and hold Start button for 10 seconds.

After holding Start for 10 seconds, all LEDs will turn on, signifying the user may
release the Start button.
Behaviors While In Consumer Error Mode

The Pause and Lid Locked LEDs should be constantly blinking while in CEM.

The first fault, if present, will show on the display.

Pressing Start will display the next fault code.
o
Models without 7-segment display: Fault code will blink in binary
– the
consumer will report which LEDs are blinking and which are not. See Binary
Display Fault Chart.
o
Models with 7-segment display: Fault code will blink on the 7-segment display.

At the end of the fault list or if no faults present.
o
Models without 7-segment display: All status LEDs will blink.
o
Models with 7-segment display: 7-segmen
t display will blink “-“.
Exiting Consumer Error Mode

Pressing any button (other than Start ) or turning any knob will exit Consumer Error
Mode.

Consumer Error Mode will time out after 10 minutes.