MAAX Spas DT6, Руководство пользователя

Страница: 27 / 54

27
27
Swim Spa
adjusted in 15-minute increments. The panel
calculates the end time and displays it.
FILTER CYCLE 2 - OPTIONAL FILTRATION
Simply navigate to the Filter Cycle 2 line by
pressing the Right Navigation Button, and
when “NO” is highlighted, press Up or Down
to toggle Filter Cycle 2 on and off. When Filter
Cycle 2 is ON, it can be adjusted in the same
manner as Filter Cycle1 by navigating to the
right. It is possible to overlap Filter Cycle 1 and
Filter Cycle 2.
CIRCULATION PUMP MODES
Some spas may be manufactured with Circ
Pump settings that allow programming
filtration cycle duration. Some circ Modes are
pre-programmed to operate 24 hours a day
and are not programmable.
PURGE CYCLES
In order to maintain sanitary conditions, as
well as protect against freezing, secondary
water devices will purge water from their
respective plumbing by running briefly at the
beginning of each filter cycle.
If the Filter Cycle 1 duration is set for 24 hours,
enabling Filter Cycle 2 will initiate a purge
when Filter Cycle 2 is programmed to begin.
RESTRICTING OPERATION
The control can be restricted to prevent un-
wanted use or temperature adjustments.
Locking the Panel prevents the controller from
being used, but all automatic functions are
still active. Locking the Settings allows Jets
and other features to be used, but the Set
Temperature and other programmed settings
cannot be adjusted. Settings Lock allows
access to a reduced selection of menu items.
These include Set Temperature, Invert, Lock,
Utilities, Information and Fault Log. They can
be seen, but not changed or edited.
UNLOCKING
An Unlock Sequence using the navigation
buttons can be used from the Lock Screen. The
Unlock Sequence is the same for both Panel
Lock and Settings Lock. Press the following
buttons: SELECT - SELECT - DOWN ARROW.
WiFi-CONNECTIVITY
See pages 29-32 to read about your spa’s Wi-Fi
capabilities. Some spas are equipped with full
Wi-Fi. See your dealer for details.
GFCI TEST FEATURE
The Ground Fault Circuit Interrupter (GFCI) is
an important safety device and is required
equipment on a hot tub installation.
Used for verifying a proper installation, the
GFCI Trip Test must occur to allow proper spa
function. Within 7 days after startup, the spa
will trip the GFCI to test it. The GFCI must be
reset once it has tripped. After passing the
GFCI Trip Test, the spa will operate normally.
SCENES
Your TP800 control has an icon labeled
“Scenes” that is not enabled. Future versions
of your spa’s software may contain functional-
ity related to the Scenes settings, but please
disregard this icon unless you receive notifica-
tion from your dealer otherwise.