t +31 88 500 2800
04
T140622-R500M
PROGRAMMING
PROGRAMMING:
Connect the 12-24V DC voltage to the terminals “-NEG” and “+12-24V”. The red power LED will light up.
The LED display displays “SCR” for a short time and then goes out. The receiver is now in normal mode.
1.
To enter the programming menu, press the “LEARN” button 1 time. If you want to exit the programming menu,
press the “LEARN” button again. The display now shows “PRO” followed by “0”.
2.
The desired user position for the transmitter can be selected with the “PLUG1” and “PLUG20” buttons.
- To increase the position number by 1, use the “PLUG1” button.
- To increase the position number by 20, use the “PLUG20” button.
If the user position is occupied the display will flash with the selected position number, if the user position is free
the position number on the display will light up constantly.
3.
When the desired position is selected as described above press the “STORE” button.
The display now shows “---”.
4.
Hold the transmitter close to the receiver (max. 1 meter) and press the transmitter button.
5.
When the transmitter has been programmed correctly, the display will return to display the user position number
and blink. If you want to learn other buttons on the transmitter or other transmitters, you can repeat this step 1 - 5.
Press the “LEARN” button again to exit the program mode and return to the normal mode.
7.
To delete a user number afterwards go into the programming menu as described above so: press the “LEARN”
button 1 time. The display now shows “PRO” followed by “0”.
8.
Then select the user position to be deleted as described above thus:
The desired user position for the transmitter can be selected with the “PLUS 1” en “PLUS 20” buttons.
- To increase the position number by 1, use the “PLUG1” button.
- To increase the position number by 20, use the “PLUG20” button.
9.
When the correct user position is selected press the “EARSE” button. The display will show “DEL” briefly and §
execute the operation of deleting the user position. Press the “LEARN” button again to exit the program mode
and return to the normal mode.
10.
To delete all users press and hold the “EARSE” button till the display shows “EAR”. Now all users are deleted.
Press the “LEARN” button again to exit the program mode and return to the normal mode.
TIMER:
Turn the time delay potentiometer clockwise to extend the switching time of the relais (0,5 - 60 sec.). The toggle function
(on/off) is on when potentiometer is turned maximum clockwise.
BUZZER:
When the transmitter signal indicates (by pushing the transmitter button) that the transmitter battery is low, the buzzer
inside the receiver will give 3 consecutive BEEP’s to remind the user to replace the battery in time.
EARSE
NC COM NO -NEG +12-24V
POWER
ANT
ST
OR
E
PLUG2
0
PLUG1
LEARN
USB
RELAIS
TERMINALS
USB
TIMER
POWER
LED
BUZZER
DISPLAY
ONTVANGER / RECEIVER / RÉCEPTEUR / EMFÄNGER
