46
Original
Version 1-2011
6.7
Changing the oil of the angle transmission
Change the oil of the angle transmission as
follows:
1.
Loosen the fastening bolts (4 pcs, in
Figure 43).
2.
Remove the belts from the belt pulley
(3 or 6 pcs, depending on the model).
3.
Turn the angle transmission so that it
can be removed, and pull it out.
4.
Open the drain opening in Figure
44, and drain the oil from the angle
transmission
into
a
suitable
container. Also open the filler
opening A to drain the oil faster.
Finish off by closing the drain
opening C.
5.
Open the oil check opening B, and
add oil through the filler opening until
the oil level reaches the oil check
opening B. Close both openings.
6.
Re-install the angle transmission, and
remember to properly align the V-
belts.
7.
Fasten and tighten the V-belts
according to the instructions in
Section 6.6.
Figure 43.
Figure 44.
The fastening bolts of
the angle transmission
