22222
MA Lighting Technology GmbH . Dachdeckerstr. 16 . 97297 Waldbüttelbrunn . Fax: + 49 9 31 4 97 94 29 . www.malighting.de
MA Booster 1 in 8 RJ45
MA Booster 1 in 8 RJ45
MA Booster 1 in 8 RJ45
MA Booster 1 in 8 RJ45
MA Booster 1 in 8 RJ45
USER INSTRUCTIONS:
Connect your MA Eight-Way Booster RJ-45 with your system.
>
NOTE:
The LOAD knob should have the basic setting of either "0" or "1".
Choose a different setting for the moving load, if the unit is going to be the last
DMX receiver.
Feed in DMX signal.
Please note, that the POWER and SIGNAL OK LEDs should be on now.
>
NOTE:
The brightness of the SIGNAL IN LED depends on the signal itself.
- THE UNIT IS NOW READY FOR OPERATION -
ACTIONS IN CASE OF AN ERROR:
If the booster can not be set in operating mode, please check the safety fuse.
Normal operation will be confirmed by POWER and OK LED.
Errors can be caused by:
- Contact problems on cables and sockets
- Short circuit and/or reversed poles within the wiring
- Missing ground or missing data cable on one of the connections
- Missing moving load resistor
- Unsuitable cable and extreme cable lengths
>
NOTE:
With total failure of the unit, only the DMX THRU output will continue working.
( Back panel print )
Measurements
19 Inch (483mm) / 1 Unit (44,5mm)
Housing
W x H x D (mm): 435 x 42 x 170
Weight
2,2 Kg
MADE IN GERMANY
-- Technical changes are subject to alterations --
LOAD 0 1 2 3 4 5 6 7 8 9
OHM 5k 1k 500 300 220 180 150 120 100 90