eMail: [email protected] . Tel.: + 49 9 31 49 79 40 . User's Manual MA Booster 1 in 8 RJ45
11111
Art.No. 130419
Art.No. 130419
Art.No. 130419
Art.No. 130419
Art.No. 130419
Eight galvanically separated outputs
DMX Input Direct DMX Output Signal LEDs
FEATURES:
DMX IN:
DMX THRU:
OUTPUTS:
LOAD:
POWER:
O.K.:
DMX Input with Overload Protection
Direct DMX Output
Eight galvanically separated, enforced outputs
All DMX Outputs are protected against overload
TECHNICAL DATA:
Power Supply
100-240 VAC / 50Hz or 60Hz
Signal in/out
DMX 512 via RJ-45;
Pin assignment:
Pin 1..3 = Not assigned
Pin 4 =
Data +
Pin 5 =
Data -
Pin 6 =
Not assigned
Pin 7 =
Data-Ground (if Jumper is set internally)
Pin 8 =
Data-Ground (if Jumper is set internally)
Screening =Data-Ground (if Jumper is set internally)
Jumper assignement:
E =
Earth (Housing)
S =
Shield of RJ-45 cable
GND =
GND of DMX
7 + 8 =
Pins of RJ-45 cable
Recommended setting:
7 + 8 spanned to GND.
(Factory setting)
E + S spanned.
So Shield is set on Earth, and pins 7 & 8 are transmitting the DMX-
GND galvanically disconnected from Earth
The MA Eight-Way Booster RJ-45 simplifies the distribution of the DMX signal and contributes to the
safe operation of your DMX equipment.
The risk of only one single loop is thus being avoided and cable loss is being reduced.
The MA Eight-Way Booster RJ-45 distributes DMX 512 (1990) signals on to 8 separate outputs.
The direct output (DMX THRU) operates an independent (from the unit) distribution of the DMX signal
(e.g. in case of power failure)).
Moving Load
MA Eight - Way Booster RJ-45
Moving Load adjustable via knob, in case this unit is the last DMX
receiver or distributor
LED confirms power supply
LED confirms the proper receipt of data
Front View of RJ45
socket
DMX IN
DMX THRU
OPTO - ISOLATED OUTPUTS
O.K.
POWER
DMX THRU USED
DMX THRU UNUSED
LOAD = 0
LOAD = 7
LOAD
EIGHT - WAY DMX BOOSTER RJ-45