MA lighting Dot 2, Руководство пользователя

Страница: 43 / 494

Try to run the cue on executor 1 on page 2 and then change the page. Notice how there's now a pattern on top of
the executor and there's a text telling you "+1 fixed from Page 2". This is because all the running executors should
as a default always be visible. So an active executor gets "fixed" when you change the page. Try to pull the fader
down. Now the executor disappeared - it went back to it's own page.
You can choose to keep an executor fixed even when it's off. What have happened so far is what's called "Auto Fix".
This means that when you turn off an executor that comes from a different page, then it goes back to that page. If
you want to keep it, then you can press
Fix and then the executor you want to keep Fixed. Try it. To "unfix" an
executor again then you press Fix and then the fixed executor.
This Auto Fix option can be turned off globally. Press Setup followed by Global Settings . This menu allows you to
enable or disable the Auto Fix function. If it's disabled, then you'll need to manually Fix the executors you want to
keep visible. Remember that if this is disabled then you could have an executor on a page somewhere that is giving
values to your lights.
Please go to the next chapter without any fixed executors but the Global Auto Fix function enabled.
Moving the Main Executor
You can even move the Main Executor.
Doing so moves it with all the settings it might have - there are small differences in the settings between a cue list
stored on the main executor and a cue list stored on one of the regular executors.
In the next chapter we are going to make more cues on the main executor.
3.10. Guide de démarrage - Fabriquer plus de cues dans la liste principale de cues
Maintenant, nous allons faire plus de cues dans la liste principale de cue et nous allons voir comment les exécuter.
Pour faire cela :
Group Up Stage At 5 0 Please
Store Time 3 Please
Cela devrait vous ouvrir un pop-up avec des possibilités différentes.
Sélectionnez celle appelée
​
Crée une seconde cue .
Cela a créé la cue numéro 2 avec un temps de transfert de 3 secondes à la place du temps de 0 secondes par
défaut.
Exécuter la cue pour voir les projecteurs du groupe 5 se mettre en place.
Essayons d'utiliser la ligne de commande au lieu des touches.
Repérez ceci sur l'écran 1:
Command Line
43