Rev 02-21-2018 Page 3 of 6
www.m7speed.com
Ultimate MINI Performance
M7 Speed
149 Byers Creek Rd., Unit 103
Mooresville, NC 28117
888-438-5767
Figure 1
CAUTION: STOP AS SOON AS THE DRILL BREAKS THROUGH.
THERE IS LIMITED CLEARANCE ABOVE THE BUMPER COVER.
8. Remove the splitter and set it to the side.
9. Pilot drill the fourteen (14) marked holes with a 1/8” drill first. Final drill the
holes
to 3/8” diameter
. Do not make the holes any larger than 3/8”. Clean
away any remaining burrs.
CAUTION: STOP AS SOON AS THE DRILL BREAKS THROUGH.
THERE IS LIMITED CLEARANCE ABOVE THE BUMPER COVER.
10. Insert the fourteen (14) plastic retainers into the 3/8” diameter holes. Push
the retainers into the holes until they snap in and are flush with the bottom
side of the bumper. It is a tight fit by design so some force will be
necessary. Do not make the holes any larger than 3/8”.
ATTACH THE SPLITTER:
11. Remove the masking tape from the splitter and bumper. Place the splitter
to the underside of you bumper. Align all the holes and thread in the
supplied Bright Zinc plated Truss Head screws through the splitter and
into the fourteen (14) plastic retaining clips.
12. Tighten all the fasteners once you are satisfied with the splitter position.
USE THESE 14 HOLES AS A GUILD TO
DRILL FOR RETAINER CLIPS