M5Stack CORE2, Руководство пользователя, Страница: 7 / 8

4. ELECTRICAL CHARACTERISTICS
4.1. LIMIT PARAMETERS
Table 8: Limiting values
1. VIO to the power supply pad, Refer ESP32 Technical Specification Appendix
IO_MUX, as SD_CLK of Power supply for VDD_SDIO.
Press and hold the side power button for two seconds to start the device.Press and
hold for more than 6 seconds to turn off the device. Switch to the photo mode
through the Home screen, and the avatar that can be obtained through the camera
is displayed on the tft screen.The USB cable must be connected when working, and
the lithium battery is used for short-term storage to prevent power failure.
FCC Statement :
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user ' s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.