M4 WiLink 1, Быстрый старт

Страница: 6 / 11

2 Setup your Router
Inset a standard SIM card firstly as shown in the following diagram and then connect the power
adapter to the power input of the router.
Press the Power button to turn on/off the router, and it will search for available mobile
networks automatically.
Do not inset or remove the SIM card when the router is running, as this may affect
performance or damage the SIM card.
To shut down the router, press and hold the power button for approximately 3 seconds.
The intuitive indicators display the router’s status
Indicator Status
SYS Power indicator
On: Device powered on
Off: Device Powered off
NET Wireless Dialing indicator
Slow Blinking: Registered to a Network
Blinking: Connected to a Network
RF More signal bars indicate stronger signals
WIFI On: WiFi is enabled
Off: WiFi is disabled
Blinking: WPS connection set up in progress
ETH On: Connected to the Ethernet network via
WAN port or LAN ports are used
Blinking: Data transfer
3 Configuring
You can configure the router using the WebUI Settings page.
1.
Launch the Internet browser, and enter http://192.168.1.1 in the address bar.
2. Enter the password, and log in to the web management page. The default password is
admin .
You also can refer to the label on the backside of the router for the default IP address
and password.
It’s strongly suggested to change the default login password of the WebUI to prevent
unauthorized users from changing the routers’ settings.
4 Connect to WiFi Network
You can connect your computer or mobile phone to the router’s WiFi network.
Default SSID: 4G-CPE-2Gxxxx & 4G-CPE-5Gxxxx
Default Password:12345678
It’s strongly suggested to change the default SSID and password by accessing to the WebUI WiFi
management page to prevent unauthorized access to your WiFi network.