M2 Antenna Systems 6M6LN, Руководство пользователя

Страница: 5 / 8

6M6LN ASSEMBLY MANUAL
STEP 4:
Insert the FIBERGLASS INSULATOR into the DRIVEN ELEMENT CLAMP. Center the
FIBERGLASS INSULATOR. Make sure the holes in the FIBERGLASS INSULATOR are vertically oriented.
Secure the FIBERGLASS INSULATOR with the bolt. Using the end with the through hole, slide one
DRIVEN ELEMENT HALF onto one end of the FIBERGLASS INSULATOR. Loosely secure the HAIRPIN
MOUNT (on top), DRIVEN ELEMENT HALF, and FIBERGLASS INSULATOR using the screw. Repeat
steps for the opposite side of the FIBERGLASS INSULATOR.
STEP 5:
Cut the BALUN WIRES to 2.0”. Strip 0.25” of insulation. Crimp and solder the RING TERMINALS.
Using the BALUN PLATE, mount the BALUN in front of the DRIVEN ELEMENT CLAMP already mounted.
Locate the screw used to secure the HAIRPIN MOUNT. Remove the screw used to secure the HAIRPIN
MOUNT. Attach the BALUN WIRE CONNECTOR (on top), HAIRPIN MOUNT (middle), DRIVEN
ELEMENT HALF and FIBERGLASS INSULATOR. Tighten screw with LOCKNUT.
STEP 6:
Using DIMENSION SHEET, locate final position of HAIRPIN. Set into position with SET SCREW.
STEP 7:
Insert a nut into the center of the COMPRESSION
CLAMP. Insert the screw into the nut a couple of turns to hold
nut in place. Slide the COMPRESSION CLAMP onto the end of
the ELEMENT CENTER. Insert the DRIVEN ELEMENT TIP into
the ELEMENT CENTER. Using DIMENSION SHEET, slide the
DRIVEN ELEMENT TIP to the correct extended length and
tighten the COMPRESSION CLAMP securely .
NUT, 8 - 32
(QTY 2)
DRIVEN ELEMENT TIP
(M2AEP0003)
(QTY 2)
SCREW, 8 - 32 X 1/2”
(QTY 2)
COMPRESSION CLAMP
(M2AMC0146)
(QTY 2)
REAR OF
ANTENNA
BOOM SECTION #1
(M2ABC6M6LN - 1)
2” HAIRPIN
(M2ADP0002)
HAIRPIN MOUNT (M2ADP0620)
SCREW, 8 - 32 X 1”
LOCKNUT, 8 - 32
(QTY 2)
SET SCREW, 8 - 32 X 1/4”
(QTY 2)
FIBERGLASS INSULATOR
(M2AFG0017)
(QTY 1)
DRIVEN ELEMENT CLAMP
(M2AEC0094)
SCREW, 8 - 32 X 2”
LOCKNUT, 8 - 32
(QTY 1)
DRIVEN ELEMENT HALF
(M2AEP0072)
(QTY 2)
BALUN PLATE (M2APT0013)
1.5” U - BOLT AND CRADLE (QTY 2)
NUT, 5/16 - 18 (QTY 4)
LOCK WASHER, 5/16” (QTY 4)
BALUN, 1:1
(FGBL0700)
SET SCREW, 1/4 - 20 X 1/4”
(QTY 1)