M.T.H. Premier 2-4-1A, Руководство оператора

Страница: 71 / 96

Discussions de cabine —F27. Elles se produisent quand la machine est à
l'arrêt, au ralenti. Il existe plusieurs moments où les membres de l'équipe
de conduite discutent ensemble, quand la machine est à l'arrêt, au ralenti.
Presser F27 (active F27) désactive les discussions de cabine. Presser F27
encore (désactive F27) réactive les discussions de cabine. Ces sons
existent par défaut.
Variables de Configuration (CV)
Variables de Configuration utilisées sur les machines MTH PS3.0.
CV1 Short Address: 1-127 are the valid addresses
CV2 Start Voltage (CV52, bit0 must =1. This will enable PWM Mode)
CV3 Acceleration Rate (CV52, bit0 must =1. This will enable PWM Mode)
CV4 Deceleration Rate ((CV52, bit0 must =1. This will enable PWM Mode)
CV5 Max Voltage (CV52, bit0 must =1. This will enable PWM Mode)
CV8 MFG ID. MTH =27. Also used for various resets
CV17 High Byte of Extended Address
CV18 Low Byte of Extended Address
CV19 Consist Address (bit 7=1 on an engine will tell the engine it’s
reversed in a consist)
CV21 Defines active Function F1-F8 for the active consist
CV22 Defines active functions for FL and F9-F12 for the active consist (bit
0=1 will tell an engine that you want it’s FL control to operate under
the consist address – bit1-0/bit2=1 will configure the FL control for a
reversed engine in a consist)
CV23 Consist Acceleration Rate
CV24 Consist Deceleration Adjustment
CV25 Speed Table Select
CV29 Decoder Configuration
CV52 MTH PWM Mode Configuration
CV53 MTH Acceleration (1/8*sMPH/s). For example – a Value of 8 written
would give you 1sMPH/s acceleration
CV54 MTH Deceleration Rate (1/8*sMPH/s)
CV55 Factory Reset Alternate method: Send a value of 55 to CV55 on
address 55 and the model will go back to Factory Default
CV63 MTH Consist Acceleration Rate (1/8*sMPH/s)
CV64 MTH Consist Deceleration Rate (1/8*sMPH/s)
CV66 Forward Trim (CV52, bit0 must =1. This will enable PWM Mode)
CV67-
CV94 Speed Table Selection (CV29 bit 4 must be set to 1 then CV25 must
be set to 0 or 1)
CV95 Reverse trim (CV52, bit0 must =1. This will enable PWM Mode)
CV105 User ID #1 – General Purpose use for customer
CV106 User ID #2 – General Purpose use for customer
CV115-
CV170 MTH Function Assignments – See table of supported CV’s and
manual section on how to re-arrange them for further information
LOCOMOTIVE À VAPEUR MOUNTAIN 241 A PREMIER
20
Vous trouverez ci-dessous le tableau des CV par défaut contenues dans le
DCC de MTH. Le tableau est spécifique à la machine décrite dans ce
manuel.