M-system R80NCIT1, Руководство по эксплуатации

Страница: 3 / 15

R80NCIT1
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EM-7026-B P. 3 / 15
COMPONENT IDENTIFICATION
Power Supply/
Exc. Supply Connecor
PC Configurator Connector
Status Indicator LED
IP Address /
Station No. Rotary SW
CC-Link IE TSN Communication
RJ-45 Modular Jack
Internal Bus Connector
PWR
D LINK
ERR
CONFIG
SD
RD
RUN
STATION No.
X16
X1
■
STATUS INDICATOR LED
ITEM ID COLOR FUNCTION STATUS DESCRIPTION
Status
Indicator
RUN Green Device State
ON Normal
OFF Device error
RD Green Receiving Data
ON Receiving
OFF Unreceived data
SD Green Sending Data
ON Sending
OFF Unsent
D LINK Green
Data link
Transmitting
ON In action (Cyclic transmitting)
Blinking
In action
(Stopping cyclic transmitting)*
1
OFF Not complied with
ERR Red Error
ON Critical failure*²
Blinking Minor failure*³
OFF Normal
CN1
LINK Green CN1 Linking Up
ON Linking up
OFF Link-down
L ER Red CN1 Receiving Data
ON Abnormality receiving data
OFF Normality receiving data
CN2
LINK Green CN2 Linking Up
ON Linking up
OFF Link-down
L ER Red CN2 Receiving Data
ON Abnormality receiving data
OFF Normality receiving data
*1. Setting as reservation area, stop linking and etc..
*2. Host communication error, internal bus communication error, and etc..
*3. Non-volatile memory error, IP address / station No. setting rotary switch has been changed after turning on the module.
■
IP ADDRESS / STATION NO. SETTING ROTARY SW
Set the fourth octet of IP address and station No. with two rotary switches. The upper rotary SW sets the upper digits (MSB),
and the lower rotary SW sets the lowest digit (LSB) with hexadecimal (configurable range is 1 to 254).
Turn off the power supply when setting IP address / Station No. setting Rotary SW, as the setting is activated when turning
on the power supply.
Confirm available station numbers in the manual of the master unit (Factory default setting: 01H).
IP address: The first to third octet are common with the first to third octet of IP address for master station.
For setting MSB of Station No. (×16)
For setting LSB of Station No. (×1)
8
67 345
2
10
F E D C B A
9
8
67 345
2
10
F E D C B A
9
* Station No. setting example
IP address / Station No. setting rotary SW are set with hexadecimal.
For example, in the case of setting station No. 175, Set the Station MSB: A and LSB: F.