background image

BEFORE USE ....

Thank you for choosing M-System.  Before use, please check 
contents of the package you received as outlined below.
If you have any problems or questions with the product, 
please contact M-System’s Sales Office or representatives.

 

PACKAGE INCLUDES:

Signal conditioner (body + CT protector) ...........................(1)

 

MODEL NO.

Confirm Model No. marking on the product to be exactly 
what you ordered.

 

INSTRUCTION MANUAL

This manual describes necessary points of caution when 
you use this product, including installation, connection and 
basic maintenance procedures.

POINTS OF CAUTION

 

POWER INPUT RATING & OPERATIONAL RANGE

• Locate the power input rating marked on the product and 

confirm its operational range as indicated below:

    24V DC rating:  24V ±10%, approx. 30mA 

 

(50mA for current output)

 

GENERAL PRECAUTIONS

• Before you remove the unit or mount it, turn off the power 

supply and input signal for safety.

 

ENVIRONMENT

• Indoor use.
• When heavy dust or metal particles are present in the 

air, install the unit inside proper housing with sufficient 
ventilation.

• Do not install the unit where it is subjected to continuous 

vibration.  Do not subject the unit to physical impact.

• Environmental temperature must be within 0 to 55°C (32 

to 131°F) with relative humidity within 30 to 95% RH in 
order to ensure adequate life span and operation.

• Be sure that the ventilation slits are not covered with ca-

bles, etc.

 

WIRING

• Do not install cables close to noise sources (relay drive 

cable, high frequency line, etc.).

• Do not bind these cables together with those in which 

noises are present.  Do not install them in the same duct.

 

AND ....

• The unit is designed to function as soon as power is sup-

plied, however, a warm up for 10 minutes is required for 
satisfying complete performance described in the data 
sheet.

COMPONENT IDENTIFICATION

Specifications

Span Adj.

Zero Adj.

Mounting Screw

Body

CT Protector

A

B

D C

 

WARNING – The CTR Must Be Connected Correctly.

1) The CT protector (model: CTR) included in the product 

package must be used for safe operations.  Turning on the 

CT without connecting the CTR opens the circuit and is 

potentially dangerous.

2) The CTR is not interchangeable with another.  Be sure to 

match the serial No. of the CTR to that of the converter.

3) Connect the CTR’s wires (C, D) and metal legs (A, B) to 

the corresponding terminals of the installation base as 

indicated in the figure to the right.  The metal legs (A, B) 

are to be secured at the base terminals together with the 

output wires from the CT.  Wrong connection may cause 

abnormally high temperature in the unit which could 

lead a fire in the worst cases.

4) Confirm the right connection of the CTR again before 

turning on the CT.

INSTALLATION

Use Installation Base (model: M8BSx).

CT CONVERTER

MODEL

M8CT

5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201  Fax: +81(6)6659-8510  E-mail: [email protected]

EM-5482  Rev.6  P. 1 / 2

INSTRUCTION MANUAL

Отзывы: