40
47DR OPERATING MANUAL EM-9509-B Rev.7
2. BASIC SETTING AND OPERATION
2.1 BASIC SETTING
This section describes flow and procedure of the basic setting.
The following shows the flow and procedure to set the input type to Pt 100 (JIS ’89), the temperature unit to °C and the
decimal point position to 2 decimal places as an example.
2.1.1 BASIC SETTING FLOW
The basic setting is as shown in the following flowchart.
2.1.2 BASIC SETTING PROCEDURE
The following shows the procedure to set the input type to Pt 100 (JIS ’89), the temperature unit to °C and the decimal
point position to 2 decimal places as an example. Set an RTD, temperature unit and decimal point position to use. Refer to
3. SETTING INPUT TYPE for details of setting.
■
PARAMETER LIST FOR BASIC SETTING
Parameters used in the basic setting are as shown in the following table.
PARAMETER
SETTING VALUE
SUB DISPLAY
SETTING
Input type
TYPE 3
RTTYPE
Pt 100 (JIS ’89)
Temperature unit
C
UNIT
Temperature indication in °C
Decimal point position
00.0
D-POINT
2 decimal places
Power ON
Starting measurement
Setting temperature unit
Setting input type
Setting decimal point position
