M-Elec NOX HIGHBAY, Руководство пользователя

Страница: 13 / 26

INSTALLATION GUIDE
DIMMING CONNECTIONS
1. Remove existing light and disconnect any
unsuitable wiring if required. Install the new High
bay with suitable mounting method.
2. Ensure you install a 'fail safe' in case the primary
supports fail on the high bay
3. Plug the new high bay into the power outlet
4. Test the high bay for safety and performance
Disconnect mains before proceeding
Please note : Do not connect anything
other than a 1-10V dimmer or control
system or the warranty will be void.
1. Open the back of the light fitting.
2.
Safely locate the purple (+) and grey
(-) 1-10V dimming cables. Connect to
your 1-10V dimming system.
3. Ensure you use suitable sealant/
glands to keep the IP rating.
4. Refit the back plate and ensure all
seals are secure. Water penetration
from a failure to seal the fitting
properly will not be covered under
warranty.
For 1-10V dimming disconnect the
purple and grey leads from the DIP
switch & connect to 1-10V circuit
T. 1300 222 445 | www.melec.com.au For further information about our Warranties please go to: melec.com.au/legal/warranties
Data subject to change visit our website for upto date infomation