VISTUS-VD
| ENGLISH
18
3. Accept the conversation on the indoor unit by pressing brie
y on
the talk button ( ).
4. If an external camera is connected to the outdoor station then you
can switch to it by brie
y pressing the ‘monitor’ ( ) button. Press
on the button again to switch back to the internal camera.
5. If a door opener is connection then you can activate it by brie
y
pressing the door opener button ( ). The bell button will light
green for the duration of the door opener as con
rmation.
6. Press the talk button ( ) brie
y in order to switch the system
back to standby operation.
Note
: If a
oor button is connected then an unchangeable ring tone
is played when the
oor button is activated. This ring tone is
xed
and is not included in the ‘normal’ tones/melodies to make it easy to
differentiate.
OPERATION (as internal house intercom)
All indoor units that are connected to the same bell button can also be
used as an internal intercom.
1. Press the internal button (B/C.7) on the indoor station from
which you wish to reach another indoor station. All the connected
indoor station will ring. No image will be shown.
2. To accept the conversation on one of the other connected indoor
stations you need to brie
y press the talk button there (B/C.6).
3. The talk button needs to be pressed brie
y on one of the two
indoor stations in order to end the conversation.
Note
: It is not possible to set different ring tones for internal and
external calls.
Technical data:
Outdoor station
Operating voltage:
15V DC
Standby power:
<0.5W
Camera resolution:
380 TV lines
Camera capture angle:
Horizontal 125°; vertical 90°
Connection for door opener: Relay contact; max. load capacity 15V/1A
Splash-proof according to IP44
Indoor station (3.5“)
Operating voltage:
15V DC
Standby power:
<0.5W
Monitor resolution:
320x240px
Bell button illumination: automatic via CDS sensor
Own melody on memory card
(max. 32 GB)
This intercom system offers the possibility to select your own ringtones,
which are stored in MP3 or WAV format on a micro SD card. The memory
card must be formatted with FAT32. You store your ringtones directly
on the SD card (without using folders), a maximum of 16 different
ringtones can be stored on the SD card. Insert the prepared SD card into
the SD card slot (B.16) on the board. The ringtones on the memory card
replace the internal ringtones. When the memory card is removed, the
internal melodies are available again.
STARTUP
Once all the components have been
tted and connected, switch on the
operating voltage. Depending on the type of installation, either plug the
mains adapter into a suitable socket or switch on the circuit breaker that
is connected to the DIN rail power supply unit. Ring the external unit
once to initialise the system (if multiple external units are installed, each
external unit must be rung once).
NOTE: Switch the operating voltage off again before carrying out any
work on the system!
OPERATION (as door intercom system)
1. Press the bell button.
2. The stored ring tone will play on the corresponding indoor station(s)
and the screen will show the image of the outdoor station.
Brightness
Contrast
Colour saturation
Speech volume
Ring tone
Bell volume
Melody VTX-Bell
(only for VTX-Bell with
4-pin connector)
VISTUS VD-600_I-Manual_210x240_Fin24.indd 18
10.12.19 14:24