M Design LUNA 1100 HC, Инструкция по установке и эксплуатации

Страница: 8 / 19

8
2.11.2 The hot-air distribution
The heat-insulated pipes are essential for optimal functioning of the device. (Causing air flow - move) Using a
larger number of tubes (minimum 2) is better traction and noise caused by a stroke is reduced. The installation of
these tubes is best to keep them upright for at least one meter up then change direction, rather do a wide bend
and the exhaust grille with less resistance to air flow, because the lower velocity means lower efficiency heat
register. We recommend that you use the exhaust grille M-design, which have many advantages / obr.11, 12 /.
NOTE: The circulation of hot air is required to be in the room does not produce any vacuum. Grid in the
floor sucking cold air/pic.12/. Do not connect it through a tube. The air itself will find a way to get to the
right place. If it is possible to mount all the accessories you use the same shape and angles, otherwise it
may happen that a grid can make much more heat than others. The hot-air distribution work on a similar
principle as the chimney, one that is warm as the first, the biggest move, and therefore becomes warm
much faster. Grills should be placed so as not to be blocked.
The exhaust grille Pic.11 by providing two connections. To simplify installation, you can use the angle profile,
which is bundled to the grid. This profile is mounted on the inside of the exhaust grille.
INDUCTION
GRID
S=2dm
2
Pic.12
Pic.11
EXHAUST GRID
MRIEŽKA
INDUCTION GRID
S=4dm
2