11
Publication: ZTB-080112
M-B Companies, Inc. 11/14/12
iNTRODUcTiON
ASSEMBLy
To Assemble the Discharge chute
Manual (Standard)
a.
Place the glide ring on top of the mounting flange. Line up the
bolt holes.
b. Place the discharge chute on top of the glide ring. The teeth
in the plate will mesh with the gear of the manual crank. The
bolt holes must line up.
c. Insert 5/16 carriage bolts through the four pairs of mounting
holes.
C
A
B
Figure 9
d. Position one of the upper slide (narrower) pieces onto the
bolts.
e. Position one of the lower slide pieces onto the bolts.
f.
Secure with a flat washer and a locking nut.
D
E
F
Figure 10
NOTE:
The standard discharge chute will have a manual
crank. When the crank is turned, the chute discharge is
redirected. This standard configuration uses a glide ring
as a bearing surface for the chute. Assemble the chute
rotation rod and gear to the body of the snowblower.
g. Mount the bracket for the manual swing controls on the front
lift assist mount. Use two bolts with washers and nuts.
h. The swing control rod will go through the hole of the manual
swing bracket.
i. Attach the plate to the side of the chute opening.
I
Figure 11
Содержание ZTB
Страница 2: ......
