Torq User Guide
»
Chapter 1
13
Torq User Guide
»
Chapter 3
13
<
CDJ Mode
CDJ mode will make the Deck behave as if it was a CDJ player. In use:
1. Pressing Play/Pause to pause playback will cause the Deck to stop and begin repeating a small section of
audio. The repeating section corresponds to the position where playback will resume when you press Play/
Pause again.
2. While the audio is repeating, you can click and drag on the Scrolling Waveform to move the start location—
you’ll hear the repeating audio slice change as you do this.
3. Clicking and dragging on the Scrolling Waveform while the Deck is playing will not stop audio. Instead, you’ll
be able to drag left or right to offset the playback speed of the track. This will allow you to align the track
against the other Deck when beat-matching.
<
Hybrid Mode
Hybrid mode provides a blend of the CDJ and Vinyl control modes:
1. Pressing Play/Pause to pause playback will cause audio to stop, just like in Vinyl mode.
2. While paused, clicking and dragging on the Scrolling Waveform will have audible results, like scratching in
Vinyl mode.
3. When playback is active, clicking and dragging on the Scrolling Waveform will not stop audio. Instead, you’ll
be able to drag left or right to offset the playback speed of the track like in CDJ mode. This will allow you to
align the track against the other Deck when beat-matching.
Looping
Technology is always evolving, thus DJing is always evolving. With the introduction of DJ CD players, DJs gained many new
exciting capabilities that were unavailable to them when working within the confines of vinyl records. One of those features
is looping, which is merely the act of repeating a section of a song.
The creative aspect of DJing suggests that a simple trick such as looping can be exploited in a variety of ways. Indeed, you
can use looping to “remix” a song by changing the arrangement—extending your favorite parts of the song. You can also use
looping as a “safety net” allowing the end of a song to play infinitely, giving you more time to mix into the next song. Looping
can also be used to isolate a section of the song, such as the breakbeat, for layering on top of other songs.
Torq offers you two different ways to loop audio. You can specify the start and end points of the loop manually, or you can
capture loops of a specific length using the QuickLoop buttons. Furthermore, Torq will help you make the perfect loop
every time by automatically matching your loop points to the tempo of the song.
<
Loop In/Out
Looping an entire song doesn’t have much benefit for a DJ, so Torq allows you to move the Loop Markers by using the
Loop In and Loop Out buttons:
1. Load a song into a Deck and press Play. The song will begin to play.
2. When playback reaches the beginning of the section you want to loop, click the Loop In button. This will place
a Loop In Marker at the Current Song Location (shown as an orange marker line in the scrolling and overview
waveforms) and the song will continue to play. The Loop In marker will snap to the beginning of the nearest
16th-note in the song waveform.
3. When playback reaches the end of the section you want to loop, click the Loop Out button. This will place a
Loop Out Marker at the Current Song Location, which will also snap to the nearest 16th-note. At the same
time, the Loop On/Off button will automatically be activated causing playback to jump back to the Loop In
Marker. The music will now loop between these two points indefinitely.
