Quattro Rear Panel:
1. “9VAC” power jack: This jack accepts the wall-wart power supply that came
with the unit. Only the proper power-rated supply should be used.
2. “To Omni I/O” connector: This 15-pin DB connector accepts the female end
of the Omni I/O connection cable (supplied with the Omni I/O).
3. USB jack: This jack accepts the device-end of a standard USB cable.
4. Audio
“In 4” through “In 1”: These 1/4” jacks accept either TRS or TS 1/4”
plugs. These are line level inputs, and generally will be connected to the
outputs of a line level instrument or preamp.
5. Audio “Out 4” through “Out 1”: These 1/4” jacks accept either TRS or TS
1/4” plugs. These are line level outputs, and generally will be connected to a
mixer, power amp, powered speakers, or a sound system.
Quattro Quick Start
It is recommended that you read this manual fully before installing and using
your AudioSport Quattro. This Quick Start guide may serve as an overview to
the steps ahead.
1. Plug the Quattro wall-wart into your wall receptacle and to the Quattro 9vAC
power jack.
2. Connect the USB cable to your computer and the Quattro. Install OMS, then
run the AudioSport Installer program supplied on the driver disk (for MIDI,
you will need to configure OMS). If you have a music program that is ASIO
compliant, drag the Quattro’s ASIO driver to the music program’s ASIO
folder. Power down the computer. Power up the Quattro, then power up the
computer.
3. With all audio levels turned down, connect your instruments to the Quattro
audio inputs, and connect the Quattro’s audio outputs to a mixer or
monitoring system.
4. Configure your music software and start recording.
2
3
5
4
1
4
