SHEET 3
1.) BEGINNING AT THE BOTTOM OF THE MOUNTING BRACKETS,
ATTACH THE STATIONARY PORTION OF THE DRAWER SLIDE BY
ALIGNING THE SLIDE'S REAR TAB INTO THE LOWEST SQUARE
HOLE IN THE REAR MOUNTING BRACKET. THEN, ALIGN THE
FRONT TAB TO THE SQUARE HOLE IN THE FRONT MOUNTING
BRACKET AND PRESS DOWN. WHEN THE SLIDE IS SEATED, THE #8
SCREW SHOULD BE INSERTED TO SECURE THE SLIDE IN PLACE.
(SEE DETAILS AT RIGHT)
2.) PROCEED WITH INSTALLING THE MIDDLE SECTION OF THE
DRAWER SLIDES. PAY ATTENTION TO RIGHT HAND AND LEFT
HAND WHEN ASSEMBLING. AFTER THE MIDDLE SECTIONS OF
THE SLIDES ARE INSERTED, MAKE SURE THE SAFETY
CATCHES ARE UNLOCKED BEFORE ATTEMPTING TO INSERT A
DRAWER.
#8-32 x 3/8"
FLAT HEAD TAPPING SCREW
(2 PER DRAWER) SUPPLIED WITH DRAWER
LH/RH MARKING
(RH SHOWN)
FRONT OF SLIDE
FRONT OF SLIDE
DETAIL SHOWING SAFETY
CATCH UNLOCKED
STATIONARY SECTION OF SLIDE
MIDDLE SECTION OF SLIDE
HOLE USED TO SECURE
SLIDE IN PLACE
NOTE: DRAWER SLIDES ARE SUPPLIED WITH THE INDIVIDUAL DRAWERS
SAFETY CATCH
Contact us direct for fast friendly service (800) 477-1255
9117-CA
DETAIL SHOWING FRONT
BRACKET PUNCHING
(RIGHT HAND SHOWN)
18" DEEP
LOCATION
24" DEEP
LOCATION